In this example we’ll wire up a DPDT rocker switch with a Firgelli linear actuator and a 12V power source.
Components
- Rocker Switch or LED Rocker Switch
- 12V Linear Actuator
- 12V power supply
- Electrical wires for making connections and crimping tool or soldering iron
Note: When choosing the rocker switch ensure you choose the suitable type for your application, either sustaining or momentary.
Wiring
Make the connections as shown in the diagram below. Either use spade connectors to connect to the switch or solder directly, always insulate with heat shrink tubing or electrical tape to avoid short circuits. Toggling the switch in one direction will extend the actuator and toggling in the other direction will retract the actuator
.
Moving Multiple Actuators
Sometimes you may want to move multiple actuators with the same switch. To achieve this attach the wires of a second Firgelli linear actuator to points “A” and “B” in the diagram above. Please be aware that the power supply recommended above is only rated for 5A, as such it is only safe to run one actuator from it. When driving multiple actuators we instead recommend using a 12V 30A power supply.
Important: Just because two linear actuators are wired to the same power supply does not mean that they will run in synchronous with each other. There are several reasons for this and several methods to ensure your actuators do all move at the same speed with each other. Please see our dedicated tutorial on this topic:
